1. Remove a steering column.
2. Remove an epiploon (71c) from the lower part of a steering shaft.
3. Disconnect the lower steering shaft (80a).

1. Check a cross beating of the lower steering shaft (80a).
2. Remove the lower arm (82).
3. Install height regulator in average situation.
4. Remove the drive of adjustment of an inclination of a steering column (top/bottom) (M20m2).
5. Remove the telescopic drive of adjustment (inside/outside) (M20m1).
6. Remove an emphasis of a steering column (83).
7. Remove an arm (85).
8. Turn off a bolt (86) of fastening of a cover and take an internal pipe from an external pipe down.
9. Sort an internal pipe.

1. Collect an internal pipe.
2. Grease an internal pipe (81b) and insert it from below into an external pipe.
3. Turn in directing a bolt (86), having combined a groove on an internal pipe (81b) with a bolt.
4. Install the telescopic drive of adjustment (inside/outside) (M20m1).
5. Further assembly is carried out as it should be, the return to removal. The maximum admissible beating of the lower steering shaft makes 2.0 mm.