4.5.5. Removal and installation of covers of a chain of the GRM drive
Removal
Details of installation of a cover of a chain of the GRM drive (1 of 3), reduction of the engine in situation 45 ° before VMT of the piston of the first cylinder (shooter)
|
|
|
1, 1a, 2 — Bolts
01 — Cores
4 — the Arm
6 — Natyazhitel of a GRM drive chain
11 — the Steering pump |
31, 34 — Asterisks final
camshafts
32, 33 — Regulators of camshafts
30, 30a — Covers |
Details of installation of a cover of a chain of the GRM drive (2 of 3)
|
|
|
a, b, d, with — Bolts
01 — Cores
02 — the Stripper
03 — the Carving insert
3 — the Water pump
14 — the Cover of a forward epiploon cranked a shaft |
15 — the Epiploon of a bent shaft
35 — the Stopper
36 — the Epiploon
37 — the Finger of the tension lever
33 — the Tension lever |
|
|
|
1. Bring the engine into situation 45 ° before VMT of the piston of the first cylinder.
2. Block camshafts by means of cores (01).
3. On the left head of the block of cylinders turn out bolts (1), (1a) and (2). Fix sideways a basic plate with the pump amplifiers of steering (11) and the attached tubes.
4. Remove forward covers (30) and (30a).
5. Mark the mutual provision of asterisks (31), (32), (33) and (34) camshafts and a chain of the GRM drive (arrow).
6. Remove a natyazhitel (6) chains of the GRM drive.
7. Remove regulators of camshafts (32), (33) and an asterisk of final camshafts (31) and (34).
8. Remove a pulley of a bent shaft.
9. Turn off bolts of fastening of the pallet and lower it.
10. Remove the pump of the cooling system (3).
11. Turn off a stopper (35) with a sealing ring (36).
12. Remove by means of a stripper (02) and a carving insert (03) a finger (37) of the tension lever of a chain of the GRM drive.
13. Remove the tension lever (38).
14. Turn off bolts (a), (b), (d) and (e) of fastening of a cover of a chain of the GRM drive.
15. Remove a forward epiploon of a bent shaft (15).
16. Remove the oil pump (25).
17. Turn off bolts (f), (g) and (h) of fastening of a cover of a chain of the GRM (9) drive.
18. Uncover a chain of the GRM (9) drive.
|
|
Details of installation of a cover of a chain of the GRM drive (3 of 3), shooters are shown places of putting motive oil
|
|
|
f, g, h — Bolts
9 — a GRM drive chain Cover
23, 24 — Sealing rings |
25 — the Oil pump
26 — the Chain of the drive of the oil pump
27 — the Asterisk of a bent shaft
29, 29a — Plugs |
Installation
Installation is made as it should be, the return to removal. Wipe sealing surfaces and grease them with sealant 002 989 47 20 10. Replace sealing rings (23) and (24), oil motive laying. Replace a forward epiploon of a bent shaft.
