8.6.5. Replacement of an epiploon of a back cover of the transmission
Details of installation of an epiploon of a back cover of the transmission
Details of installation of an epiploon of a back cover of the transmission
|
|
|
2 — the Driveshaft
5, 21, 200a — Bolts
6, 20, 36 — Washers
7, 35, 88, 200 — Nuts |
18 — an engine Support
19 — an engine Arm
56 — the Epiploon
87 — the Flange |
Removal
Details of installation of an arm of a support of a suspension bracket of the power unit
|
|
|
18 — the Support of a suspension bracket of the power unit
19 — the Arm
21 — Fixing bolts
35 — the Fixing nut |
|
|
|
|
1. Lift the transmission by means of a jack.
2. Turn off a nut of fastening of a support of the engine (35). Turn off bolts (21) with washers and remove an arm (19) together with a support of an engine mount (18). |
|
3. Unscrew the driveshaft from the transmission. Turn off a bolt (8) of fastening of a shaft of a speedometer (9) and remove it. |
|
|
4. Weaken adjusting plugs in a driveshaft flange. For this purpose use a drift with a diameter of 10 mm and about 150 mm long. |
|
|
5. Weaken a nut of the driveshaft and move the driveshaft from a flange towards a back part of the car. |
|
|
6. Turn off bolts of basic assembly (200a). |
|
|
7. Turn off a nut of fastening of a flange of the transmission. |
|
| 8. Remove a transmission flange. |
| 9. Having hooked the screw-driver, take an epiploon from a transmission cover by means of the screw-driver. |
|
|
Installation
Installation is carried out as it should be, the return to removal.
