90fcb7d0

8.6.11. Adjustment of the mechanism of gear shifting

Details of installation of elements of the mechanism of gear shifting

Gear shifting mechanism design

201 — the Decorative handle
202 — the Casing
203 — the Nut
204 — the gear shifting Lever
206, 221 — Springs
204, 226 — Lock rings
218, 211 — Plugs
209, 225, 279 — Fingers
310 — a switching Fork

213, 227, 233 — Bolts
216 — a bearing Cover
218, 220, 239, 240 — Laying
224 — the Lock eye
230 — the Arm of bearings
231 — the Lock plate
230 — Plastic laying
236, 237, 238 — Intermediate levers of switching


 PERFORMANCE ORDER

1. Install the lever of gear shiftings in neutral situation, then disconnect switching levers from drafts of switching on the gear shifting mechanism after removal of lock clips (37).
2. Arrange three intermediate levers in the following sequence: transfer back the хода/1st - I am transfer, 2/3 transfer and the 4/5th transfers and block them a lock finger through openings.
3. Weaken lock nuts (arrows) and adjust length of each draft.
4. Remove a lock finger from intermediate levers of gear shifting.
5. Check gear shifting at the working engine.