90fcb7d0

8.2. Removal and installation of the transmission

Removal

Removal and RKPP installation

3 — the Bearing coupling switching off
4 — the coupling switching off Lever
6 — the Heat-shielding guard
6, 7 — Nuts
9 — a speedometer Shaft
10 — the Arm of fastening of system of release
11 — the Bracket
19 — an engine Support

27 — a connection Wire on "weight"
32 — the Clamp
33 — Shplintovy connection of the leading shaft
60 — System of release
71 — the Forward part of the driveshaft
85a — the Inductive sensor


 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove a support of the engine (19).
3. Remove an arm of fastening (10) of system of release (60) and a bracket (11).
4. Remove a heat-shielding guard (5).
5. Turn off a forward part of the driveshaft (71).
6. Disconnect system of release (60).
7. Turn off a shaft of a speedometer (9) or the inductive sensor (85a).
8. Disconnect a tube (shooter) of the hydraulic pipeline of coupling.
9. Remove a clamp (32) and disconnect drafts of gear shifting.
10. Turn off a connection wire on "weight" (27) from the transmission.
11. Turn off bolts of fastening of the transmission to the engine.
12. Grease shplintovy connection of the leading shaft (33).
13. Check the persistent bearing (93), the lever of switching off of coupling (4) and the ball-bearing of a bent shaft.

Installation

Installation is carried out as it should be, the return to removal. Check oil level in the transmission and adjust it on bottom edge of a filling opening. The volume of oil makes 1.5 l.