90fcb7d0

13.4. Removal and installation of the dashboard

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove a steering wheel, a guard of devices, the combined switch, side moldings, covers of loudspeakers on both sides, a cover of a ware box, the lower cover of the dashboard, a cover on the gear shifting lever, side and central deflectors.
3. Remove the deflector (1), turn off a bolt (2) and remove a clip (3).
4. Disconnect sockets of conducting of the rotating switch of light of headlights of the regulator of light of headlights and a bulb of illumination of the switch of headlights.
5. Remove the drive of the regulator of a steering wheel. For this purpose press the button, turn off a bolt (4), uncover (5) up.
6. Turn off a bolt (6) and remove the case (7). Do not unhook a cable of management.
7. Remove a cable (8) of an otpuskaniye of the parking brake and remove the handle (9).
8. Unhook a cover on the wooden panel.
9. Turn off fixing bolts.
10. Remove the wooden panel (10).
11. Turn off bolts (11) and (12), remove the panel of regulators (13) and disconnect sockets of conducting and cables of management from a heater.
12. Remove the side deflector (14) and a clip (15).
13. Turn off bolts (shooters) (8 mm) in the top part of the console.
14. Turn off bolts (shooters) of fastening of the dashboard (10 mm).
15. Lift the dashboard over the central console (arrow), then pull the panel from the passenger back and remove it from a steering column and the lock of ignition.
16. Disconnect an electrical wiring from the dashboard from the driver (shooter).
17. The dashboard in the removed look is shown on an illustration.

Installation

 PERFORMANCE ORDER

1. Adjust reference points so that the top part of each panel coincided with the wooden panel on doors.
2. At first install the dashboard on a forward wall from the driver (to put on it a steering column), the ignition lock, the top air ducts and fixing flanges on the central console.
3. Establish insulating laying (16) and (17), an electrical wiring and cables of management.
4. Wrap seven bolts (arrow) and tighten them.
5. Attach sockets of conducting of the rotating switch of light of headlights, the regulator of light of headlights and a bulb of illumination of the switch of light of headlights.
6. Install deflectors on both sides. Establish a clip on a forward wall of a body.
7. Install regulators and attach cables of management of a heater and sockets of conducting.
8. Install the decorative wooden panel.
9. Further installation is carried out as it should be, the return to removal.