90fcb7d0

13:26. Check and adjustment of provision of headlights

Adjustment of a tilt angle of light of headlights

a — the Mark for adjustment of passing beam of headlights
b — the Mark for adjustment of driving beam of headlights
with — the Mark for adjustment of light of fog lights

 

Adjustment of a tilt angle of light of headlights

е — the Adjusting size for a tilt angle of light of headlights
% n — the Inclination of light-and-shade border
N — Height of the middle of a tilt angle of light of headlights
h — Light-and-shade border



 PERFORMANCE ORDER

1. Install the car on the flat platform. Adjust air pressure in tires. With system of adjustment of a road gleam or the ADS system the engine has to work for cars about 30 minutes on average turns.
2. Carry out reading of the adjusting parameter (%) for the main and additional headlights on a headlight of the car and establish it on a device scale for check and adjustment of a tilt angle of headlights. The inclination of 1% of "n" corresponds to 10 cm of the adjusting e size.
3. Install the device for check and adjustment on one axis with the car and make vertical adjustment according to tags on a reflector.
4. Start the engine and turn on passing beam of headlights.
5. Check operation of the regulator of a tilt angle of light of headlights. Light beams of both headlights have to move evenly.
6. Install the regulator of a tilt angle of light of headlights in situation "0". On models with xenon headlights remove additional small weights.
7. Check passing beam of headlights and, if necessary, adjust it. At vertical adjustment the border of a light beam has to coincide precisely with the horizontal line (4) devices, at horizontal adjustment the inclined line (5) has to leave a point of intersection of the vertical line (6) with the horizontal line (4). The general block reflector on models with a body the Sedan, since 03.94 g of the issue, provides simultaneous adjustment of a tilt angle of light of headlights and fog lights.
8. Check adjustment of driving beam of headlights. The center of a light beam has to be on the corresponding central mark (6). At a deviation check installation of a bulb of an incandescence.

9. Check and adjust light of fog lights. The border of a light beam has to coincide as it is possible more precisely with the horizontal line (4). If necessary, modify its situation. On the Sedan models, since 03.94, check dense landing of a bulb of an incandescence.