4.4.17. Removal and installation of the pallet of a case of the engine
Details of installation of the pallet of a case of the engine
|
|
|
3 — Laying
4 — the Pallet
5, 15, 22 — Bolts
7 — I Will corrode conductings of the sensor
oil level
8 — the oil level Sensor
9a — Laying |
14, 21 — Oil pipelines
22a — Support
23 — Nuts
24 — the oil pressure Sensor
25 — Pruzhina
26 — the Stabilizer of cross stability |
Removal
|
|
1. Disconnect a negative wire from the battery.
2. Remove an air inlet.
3. Disconnect the lower protective guard of the engine.
4. Merge motive oil (about 7.0 l). Replace laying and screw a drain stopper. |
| 5. Turn off bolts of fastening (a) of a forward support of the engine. Turn off nuts (b) of fastening of the stabilizer (2). Replace самоконтрящиеся nuts. |
|
6. Disconnect the socket of conducting (7) from the oil level sensor.
7. Disconnect the socket of conducting (24) from the oil pressure sensor. Fix it so that not to damage it when raising the engine.
8. On models with AT disconnect oil pipelines (14) and (15) from the pallet.
9. Disconnect oil pipelines (21) from the pallet.
10. Remove the stabilizer (26). |
| 11. Lift the engine by means of the elevator. |
|
| 12. Remove springs of a forward suspension bracket. |
| 13. Lift a forward axis by means of the winch. Turn off plastic covers over two back points of a forward axis. |
|
14. Turn off four bolts of fastening of a forward axis. Wipe carving openings, and replace fastening bolts with new.
15. Lower a forward axis. |
| 16. Turn off bolts of fastening of the pallet, move it forward and lower it. Remove it, having moved forward. Replace bolts and laying (3). |
|
|
Installation
Installation is made as it should be, the return to an order of installation of components. Track observance of requirements to fixture inhaling moments.
