12.3.2. Removal and installation of the lower spherical support
Removal
|
|
| 1. Remove a forward wheel. |
| 2. Turn out the lock screw screwed in a brake board. Give an axial nut (7a) of the basic hinge of a spherical support. |
|
| 3. Screw on an axis of the basic hinge of a spherical support a persistent element (044b), delay outside a brake disk with a board and by means of a stripper (044) No. 140 589 09 33 00 separate the basic hinge from a rotary fist. |
|
| 4. Turn out a hinge nut from the lever. |
| 5. Working in a similar manner, release a spherical support from the suspension bracket lever. |
|
| 6. In case of need smooth out conical elements of hinged assembly. |
| 7. Estimate a condition of a protective cover (7f) and wire collars (7d and 7h) its fastenings. In case of need make necessary recovery repair, or replace the failed components / hinged assembly. |
|
|
Installation
Installation is made upside-down.
Tighten самоконтрящиеся nuts of fastening of a support with the required effort (to a rotary fist:
140 Nanometers, to the lever:
100 Nanometers). The lock screw on a brake board tighten with effort
22 Nanometers, on a brake disk – with effort
of 10 Nanometers.
