10.3.1. Removal and installation of a flange of a power shaft and radial-stop ball bearing
Removal
Flange of a power shaft and radial-stop ball bearing
|
|
|
1. Remove a power shaft.
2. Remove a brake disk.
3. Remove blocks of the parking brake system.
4. Take a flange of a power shaft (10) (at the established wheel support).
5. Remove a lock ring (9).
6. Remove the radial-stop ball bearing (8) from a wheel support.
7. Take an internal ring of the bearing from a flange of a power shaft. |
|
Check
Check an axial and radial beating of a flange (10) of a power shaft. The extreme admissible size of an axial side play of a flange makes
0.03 mm, a radial beating - also
0.03 mm.
Installation
Installation is carried out as it should be, the return to removal.
Flange of a power shaft
Removal
Removal of a flange of a power shaft
|
|
1. Insert a carving bolt (010j) into a flange (10) outside and tighten it to an arm (010g).
2. Install the support plate (010d) on a wheel support. |
| 3. Establish a clamping plate (010f) with a clamping bolt (010b) through an arm and install on the support plate (010d) again. |
|
| 4. Establish a hydraulic press (010h) between persistent laying (010f) and an arm (010g). Turn off clamping a bolt (010k) from a hydraulic press, then a bolt (010i) of an arm until it does not concern the clamping cylinder of a hydraulic press. |
|
| 5. Screw clamping a bolt (010k) of a hydraulic press (the maximum moment of 40 Nanometers) until the flange of a power shaft is not removed). |
|
| 6. Strike with the hammer an arm (shooter). |
|
| 7. If it will be not enough, turn out a bolt (010i) from an arm. |
|
|
Installation
Installation of a flange of a power shaft
|
|
|
7 — a wheel Support
8 — the Two-row radial-stop ball bearing |
|
Install a flange (10) on the two-row radial-stop ball bearing (8), using the adjusting tool (08a) - (08s), (08e) - (08i). Make sure that the small clamping plate (08s) is correctly established on an internal ring of the bearing (shooter).
Two-row, radial-stop ball bearing
Removal of the two-row radial-stop ball bearing
|
|
|
7 — a wheel Support
08 — the Two-row radial-stop ball bearing
08a — the Bolt with a nut
08b — the Stripper
08s — Persistent laying (small) |
|
Installation of the two-row radial-stop ball bearing
|
|
|
7 — a wheel Support
8 — the Two-row radial-stop ball bearing
08a — the Bolt with a nut
08b — the Stripper
08s — Persistent laying (small)
08e — Clamping the bearing |
|
