10.4.7. Replacement of the cylinder of differential with automatic blocking (model 140.028/032/033 till 31.05.94 of the issue and 140.1 with a code 211a)
|
|
Diameter of differential is 210 mm. |
Replacement of the cylinder of differential with automatic blocking (diameter of differential of 210 mm)
|
|
|
30 — the Lock ring
33b — the Flange
33c — the Ball bearing
50 — the Reducer
54 — the Back cover |
56, 56b — Bolts
70b — the Piston
70d — the Rubber cover
70h, 70j — Sealing rings |
|
|
1. Remove a reducer (50).
2. Merge oil from a reducer.
3. Remove a back cover (54).
4. Disconnect a lock ring (30).
5. Remove a flange (33b).
6. Remove the ball bearing (33c). |
| 7. By means of the screw-driver to a vypressuyta a rubber cover (70d) from a bearing cover. |
|
| 8. Insert a stripper (07l) into the piston (70b) and remove a sealing ring (70j), remove a rubber cover (70d) from the piston (70b), remove the piston (70b) from a side cover of the bearing, weaken a tube of a sapun (shooter). |
|
| 9. Remove sealing rings (70h) and (70i) and do not establish them twice. Grease carefully the piston (70b) with hydraulic liquid (specification 343.0) and press it. Grease connection of a sapun after a piston press fitting. At a piston press fitting in a side cover of the bearing, be convinced that grooves were combined with a roller finger (70c) or an opening (shooter). |
|
| 10. Replace a sealing ring (70j), - for this purpose, grease a sealing edge with universal gipoidny transmission liquid and press it by means of a drift (073). |
|
| 11. Using a press of small diameter (072b), press a rubber cover (70d) on the piston. |
|
| 12. By means of a press of bigger diameter (072a), press a rubber cover (70d) on a side cover of the bearing. |
|
13. Further all procedures are carried out upside-down.
14. Pump over hydraulic system of blocking of differential. |
|
